Fuse & Tear® is a fusible tear-away stabilizer with a low melt fusible coating.

Developed for embroidery on light weight woven fabrics Fuse & Tear® is for shirt weight fabrics, linens etc eliminating any movement or slippage when they are hooped or while embroidering. This fusible tearaway eliminates the need for messy spray adhesives which leave a residue on needles, hoops and fabrics.

The low melt 260 degree F fusible was made to prevent scorching or shrinking of fabric.

The fusible bond prevents movement or slippage leading to accurate registration.

This product offers a clean & easy tear from your design after embroidering.

• Use for dense designs on lightweight woven fabrics such as linens &, shirt weight fabrics.
  
• Eliminates any shift or movement of the fabric while embroidering
  
• Will support approximately 6,000 stitch count of a moderately dense well digitized design.
  
• Tears away very cleanly.
  
• Eliminates messy or toxic spray adhesives!

Design by www.ishkabbibbelinc.com

Directions:

1. Fuse one layer of Fuse and Tear® to the back of the fabric to be embroidered before hooping. Be sure to use a piece slightly larger than the hoop to insure proper hooping tension *Important - Use a low to medium temp 260 degrees F - silk setting on your iron. A press cloth underneath your iron is recommended.
   
2. Hoop the garment and stabilizer. Try to achieve or approach a “tambourine skin” type tension in your hoop.
   
3. Embroider your design. If the design is dense or more than the suggested number of stitches float another layer of tearaway under the hoop and the first tearaway layer for extra support.
   
4. Once the design is complete tearaway the excess stabilizer.

If you are interested in purchasing Fuse & Tear please click here.

If you would like to purchase Fuse & Tear in precut sizes, please click here.

Looking for more stabilizers and backings click here.

Looking for other embroidery supplies click here.